Qualcomm OBDII J1708 Guía para resolver problemas Pagina 94

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 110
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 93
General Installation Guidelines General Wiring and Installation Guidelines
C-8 80-JB566-1 Rev. C
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
General Installation Guidelines
Determine the most direct and protected route when routing cables to connect the
components to each other and to the vehicle.
Do not trim cable lengths to fit a specific vehicle.
Use only wire strippers for stripping wires.
Use only the appropriate insulated crimping tool for crimping insulated connectors.
Use existing holes for cable routing whenever possible.
Avoid running cable over or near heat sources.
Routing and Protecting Cables
Provide strain relief for all cables
Use tie wraps
Debur any drilled holes
DO NOT route cables:
Near audio system amplifiers
Near exhaust pipes and other sources of heat
Near the brake, clutch, or accelerator pedals, and linkage
Near foot traffic areas
Near the windshield wiper mechanism
Near CB radio wires
Over sharp edges
Over moving parts
Special Interior Routing Guidelines
Route cables under kick plates or carpets.
Avoid high foot traffic areas.
When reinstalling dash panels, be careful that screws do not penetrate cables.
Route cables with any existing vehicle cables.
Storing Excess Cabling
Secure excess cabling with tie wraps.
Stow out of sight.
Stress Relief
Ensure cables have enough slack so connections are not being pulled.
Vista de pagina 93
1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 109 110

Comentarios a estos manuales

Sin comentarios